1American O'Hare SHRK07AL1 Simulation Control 2D Swinging BedTechnical parameters:

1. Speed range: 1-75 rpm

2. Tilt angle: 0-15 °

3. Timer: 1 to 120 minutes

4. Load capacity: 7.3 kg

5. Tray material: Aluminum

6. Tray size (length x width): 35.6 x 27.9 cm

7. Transport weight: 7 kg

IIAmerican O'Hare SHRK07AL1 Simulation Control 2D Swinging BedOperation characteristics:

1. Low body design: takes up less space and can fit into most fume hoods and incubators. Two layer selection
The use of the same floor space has increased the load capacity, and there is an 8.9 cm gap between the platforms
Gap. The cast aluminum base provides durability and higher stability.
2. Microprocessor controller: The microprocessor control provides tilt adjustment, allowing users to adjust the device
Easily adjust the swing angle from 0 to 15 ° while running. Smooth speed of low-speed swinging motion
Control.
3. Independent control knob: Speed, tilt, and time are controlled with independent knobs for easy and convenient adjustment.

IIIAmerican O'Hare SHRK07AL1 Simulation Control 2D Swinging BedGuarantee:

1. Overload protection: When the system detects obstacles or overloaded trays, it will emit an audible signal.

2. Slowly increase speed: Slowly increase the speed to the target set value to avoid splashing.

3. Timing range: When the timer reaches zero, it will automatically stop the swinging motion.

4. Anti overflow design: Use a diversion groove to keep the fluid away from internal components.

4American O'Hare SHRK07AL1 Simulation Control 2D Swinging BedWorking conditions:

1. The device can be used in freezers, incubators, and non condensing dioxide at -10 to 60 ° C and humidity up to 80%
Operating in a carbon environment.

5American O'Hare SHRK07AL1 Simulation Control 2D Swinging BedApplication:

1. Staining and decoloring gel, hybridization procedure, hematology and impregnation technology.