FT-103BDust resting angle tester

FT-103B

powder angle of repose meter1Refer to standard requirements

Standard requirement

Dust angle of repose tester

GBT 16913-2008 Dust Physics Test Methods Dust Resting Angle Tester (Injection Limited Bottom Method)

GBT 16913-2008 powder physical test method

of powder angle of repose tester (injection limit underside method)

This product is used by production, operation, and user laboratories to measure the physical properties of dust.

The product is used for the physical

performance of powder in production, operation and use of unit laboratories.

2、 Principle:

Inject the dust piled up in the overflow tray from the funnel into the horizontal tray; Measure the acute angle between the inclined plane of dust accumulation and the horizontal plane at the bottom, which is the dust resting angle.

Inject enough powder from the funnel into

the horizontal disc.Measure the acute angle between the incline and the bottom

of the surface of the powder, namely the powder angle of repose

3、 Parameter information: Technical Parameters

Cone taper of 60 °± 0.5 °;

Funnel taper 60°± 0.5°

The outflow diameter should be 5mm, and the center of the funnel should be perpendicular to the center of the lower tray;

Outlet diameter 5mm, the center of the

funnel and the center of the lower tray should be on a vertical line.

The distance between the bottom edge of the outflow port and the disc surface is 80mm 2 mm, and the protractor is 7.5cm~10cm;

The distance between bottom of outlet and

disc is 80mm 2 mm, protractor7.5cm~10 cm.

The diameter of the tray is 80 mm,

A measuring cylinder with a capacity of 100 ml;

Tray diameter 80 mm, cylinder volume 100

ml.

Flat dust scraper blade, rod needle;

Flat dust scraping blade, needle bar.

Comprehensive analysis solution for powder:

FT-3400 Powder Flow Behavior Analyzer (Static Mechanics, Shear Method)

FT-7100 Powder Flow Tester (Dynamic Mechanics, Drum Method or Rotary Cylinder Method)

FT-3900 Powder Yield Strength Analyzer (Uniaxial Compression Method)