Specifications
|
explain
|
Power Supply
|
1. 2 ends are 85~260VAC power supply terminal (single-phase phase-shift trigger power supply)
|
Output
|
4. Terminal 5 is the phase-shift trigger control output terminal
|
Input
|
8. Terminals 9 and 10 are control signal input terminals
·The potentiometer signal input is connected to 8, 9, and 10 (with a potentiometer value of 1K)~Between 10K, with the middle tap connected to 9)
·The voltage signal input is connected to 9 and 10 (9+, 10-), and the voltage signal is 1~5V)
·The current signal input is connected to 9 and 10 (9+, 10-), and when the current signal is 4~At 20mA, input terminals 9 and 10
A 250 Ω/0.25W resistor should be connected in parallel
|
Rated input voltage
|
Three phase 380V, 50Hz special voltage requirements can be customized
|
Triggering thyristor
Rated current
|
5A~8000A
|
load property
|
Resistive, general inductive, pure inductive, transformer primary side, secondary side, inductive coil and other large inductive loads
|
input control signal
|
4~20mA, 1~5V, manual potentiometer control
|
Installation method
|
Standard DIN rail installation
|
Power consumption (typical value)
|
1.2W
|
Interface
|
Plug in screw terminal block
|
External dimensions
|
71×111×28mm
|
Usage environment
|
|
Altitude not exceeding 3000 meters
|
ambient temperature
|
-30℃~55℃
|
relative humidity
|
≤85RH
|
|
The operating location is free of conductive and explosive dust, corrosive metals, and gases or vapors that damage insulation
|
|
No severe vibration or impact
|