SHY-2 water bath constant temperature oscillatorDetailed explanation:

1、 Usage: Water bath constant temperature oscillatorMainly suitable for oscillation cultivation of various liquid and solid compounds such as biology, biochemistry, cells, and bacterial strains in various universities, medical, petrochemical, health and epidemic prevention, environmental monitoring and other scientific research departments. This machine has the characteristics of reasonable structure, easy operation, and high stability performance, making it an ideal equipment for laboratory workers to handle with ease.

2、 Main technical performance:
1. Power supply: 220V 50HZ
2. Whole machine power: 1800W
3. Operation mode: Spinning
4. Oscillation frequency: adjustable from -300 revolutions per minute during start-up
5. Oscillation amplitude: 20mm
6. Constant temperature range: room temperature -100 ℃ Temperature control accuracy: ≤ ±0.5℃

3、 Product Structure:

Water bath constant temperature oscillatorAdopting a sink type inner liner, imported stainless steel welded shell, using high-quality cold-rolled plate and spray coating process, the surface is bright and wear-resistant. The electric heating tube is clamped at the bottom of the water tank, which heats quickly, has high thermal efficiency, low power consumption, intelligent digital temperature control, suppresses temperature shock, and ensures temperature control accuracy.

4、 Usage:

1、Add an appropriate amount of water to the water tank (the water level should be 2-3cm above the spring clamp),Put the reagent bottle on the spring clip.

2Firstly, connect the power and turn on the heating switch,The temperature controller lights up,At this point, click the SET function button on the temperature controller,At this point, click the set function button on the temperature controller. The upper row displays sp and the lower row displays the set temperature. Click the △ or ▽ button to select the desired working temperature. After setting, click the set function button again to enter the constant temperature timing setting. The upper row displays st and the lower row displays the set time,click▲perhaps▼Select the constant temperature timing time with the key (if timing is not required, set the time to0Just click the set button again to exit the setting state. At this time, the temperature inside the box is running at a constant temperature according to the set temperature; After running, the buzzer will sound an alarm and stop heating.

3Adjust the oscillation "timing knob", select the oscillation timing time (if timing is not required, adjust the timing knob to the normally open position), and then slowly adjust the "speed control knob" to the desired oscillation speed.

4After use, adjust the speed control knob to0Turn off the power, if not in use for a long time, unplug the power, drain the water, clean and wipe it clean in a timely manner to extend its service life.

5、 Attention:
1. The instrument casing should be properly grounded to prevent accidents.
2. All kinds of solutions are strictly prohibited from entering the control room to avoid damaging the host.
3. It is strictly prohibited to heat the water tank without water to avoid burning out the heating tube.