DY-LD50 Dew Point Analyzer is a complete dew point measurement system, including filtration and flow control. It is compatible with Chuanshuo's humidity series products and is used for measuring pressure dew point or atmospheric dew point.

Highlights

*Easy to use

*Sample gas filtration

*Flow control

*Atmospheric or pressurized dew point

*Gas pressure up to 10 MPa

application

*Compressed air drying

*Plastic particle drying

*Ozone generator

*Medical gases

*Pneumatic system

*Breathing gas

*Welding gas

*Air separation and oxygen production equipment

DY-LD50pretreatment system

To ensure accurate and stable humidity measurement, expose the hygrometer to a sample gas that can represent the monitored gas

Middle is very important. The sample gas must be free of pollutants and at the correct pressure and flow rate to

It can quickly respond to changes in the measured gas.

The DY-LD50 dew point analyzer pre-processing system is an economical solution for dew point transmitters, while also providing the necessary pass through

Filtering, pressure regulation, and flow control. In specific applications such as compressed air, medical gases, or process control

In the middle,DYLD50The sampling system can be specially customized to fully meet the unique requirements of users and dew point instruments.

Filter module

DYXT-LD50 can be equipped with particle filters or coalescing filters. If there is no risk of mixed gas in the sample gas, then a simple particle filter can be equipped, and its stainless steel sintered filter element provides7 micron

graded99.5%The filtering protection rate. If there is liquid present, equip with a coalescing filter with emptying function.

Performance product parameters

measuring range-80℃ to +20℃Dew point (order code)V）；-100℃to +20℃Dew point (order code)M）；0-3000ppm(Optional); Sensor capacitance method
Accuracy:+-2℃dew point
Response time:5 Minutes to arriveT90(Dry to wet)
resolving power:0.1℃dew point
Checkpoint: Traceable13 Point calibration; Suggested verification cycle2year

Electrical input/output
Output signal:4-20mA;Modbus485 RTU
(Optional)Output unit:℃dew point;PPMvMoisture content (only)M
Probe)Output unit range:-80℃to+20Dew point（VProbe);-100℃to+20℃Dew point（MProbe)
;PPMSee orderPower supply display table:AC 220V
; SensorDC 12-28VAlarm function: flashing alarm, relay alarm output (only configured)WC、
XCThe display table has this functionCurrent consumption:

0.5A
maximumoperation conditionOperating temperature: sensor-40℃arrive+60℃; Display Table0℃arrive0 +50℃;Diaphragm air pump
arrive40℃Operating pressure:5Mpa（VProbe);10Mpa（
MProbe)Traffic:
1 to5NI/min

Installed in the sampling system
Temperature coefficient: Temperature compensation within the operating temperature range Mechanical specifications280 chiInch:long*180wide
*350Highly customizableFilter: Sensor Protective Cover StandardHTPE<10micron7 ;
Particle filtermicronProtection level: ChassisIP54
Optional display of interior door installationIP55Diaphragm air pump:220 VAC;No load flow rate12L; Diaphragm25000 EPDM;
lifetimehourPipeline material:
6mm 316Lstainless steelSampling system module: filter; Needle valve;
1...5NIFlowmeter; cellAir intake/Air outlet:
6mm2 DSJ-MCable interface:holeM20*1.5