This series of torque signal couplers is equipped with:

1.Torque measurement function;2Energy and signal non-contact transmission function, threeDigitization function of output signal.

4.Can transmit static torque signal, rotational torque signal, dynamic torque signal, static torque signal,

5.The transmission of signals is independent of rotation, speed, and direction. Can adapt for a long time,High speed operation.

6. High precision and good stability;7.Small size, light weight, easy to install;

8. Continuous transmission of forward and reverse torque signals without the need for repeated zeroing;

9. Without wear parts such as collector rings, it can operate at high speed for a long time;10. Strong anti-interference ability;

2、 Technical indicators

1.Range:5、10、20、50 、100，200Ｎ·m 2.Precision:０.5%Ｆ·Ｓ

3.Applicable speed4500change/Below divided.4.Environmental temperature:０℃-５0℃ 5.Frequency response:100 μs 6.weight4.5 Kg 7.output signal: 0-12vSquare wave frequency;Zero torque: 10 KHZ ;Positive full-scale: 15 KHZ ;Reverse full-scale: 5 KHZLOAD<10mA.

8.Signal socket: (1)0V. (2)+15V. (3)-15V. (4)(empty)．(5)Torque signalPlease refer to the specific requirements when leaving the factory

This series of torque signal couplers can work for a long time due to the induction power supply of transformers,Widely used for torque monitoring of mixers and viscometers.

3、 Installation:

1.Install the sensor with torque signal coupling between the power source and the load using a set of couplings.

2.Suggest using flexibility.Elastic or universal joint coupling to ensure concentricity ∠0.1mm

3.Fix the end face of the torque signal coupler housing radially flexibly on the base.

4、 Signal processing

1. Directly send the torque frequency signal to the computer orPLCCarry out processing;

2. add80FThe conversion module can be transformed into4—20mAperhaps1—5Vanalog signal.

5、 Usage precautions:

1. The wiring must be correct; 2.±15VRange:Not less than ±14.5VNot exceeding ±15.5V ;

3. The signal line output must not be grounded,Short circuit to power supply,The output current is not greater than10mA;

4. The shielding layer of the shielded cable must be consistent with ±15VConnect the common terminal (power ground) of the power supply.

5. If you have any questions during use, please contact our company in a timely manner,During the warranty period, it is not allowed to disassemble by oneself.

External dimensions (please contact our company for specific dimensions)

Our torque sensors can be manufactured according to customer requirements.