1. It can be used for solid solid (powder and powder) mixing, solid-liquid (powder and liquid) mixing, and drying operations. It can also be used as a reaction equipment. In addition, we can provide special design and processing according to your requirements.
2. The material is in a state of weightlessness due to mechanical action inside the machine, widely interlaced to produce convection and diffusion, thus achieving uniform mixing. The range of materials suitable for mixing is very wide, and there is no segregation when mixing materials with significant differences in physical properties such as specific gravity and particle size. Overcoming the weaknesses of some mixers to obtain high-precision mixtures.
3. The mixing accuracy is high, and the standard deviation of solid solid mixing at a ratio of 1:1000 is between 0.3% and 0.8%, with a passive error of less than 2% (variation factor) in the content.
4. Even if there are differences in the specific gravity and particle size of the materials, good mixing effects can still be achieved under the rapid and intense agitation and scattering of the staggered mixing blades.
5. When materials have clumping and agglomeration phenomena, it is necessary to add a crushing device. The "crushing rod" with a triangular tooth cover should maintain a high speed of 1400rpm or above to crush and depolymerize the agglomerated materials in the material weight loss zone.
6. The discharge form is generally pneumatic (manual) flap valve, and the circular arc valve is tightly embedded in the cylinder, flush with the inner wall of the cylinder, without material accumulation and mixing dead corners; The standard model can be divided into large and small doors. The large door opens to the edge of the cylinder, allowing for clean and quick material discharge with minimal residue.
7. To reduce the cost of replacing vulnerable parts of the equipment, the blade blades can be made into two pieces, and a movable small blade can be placed on the blade base to directly replace worn small blades, which is economical and fast.
8. The gap between the blade and the cylinder wall directly affects the mixing effect and the residual materials inside the machine after discharge; Our company's product blades and cylinder clearance are controlled at 3-5mm
9. The mixing speed is fast, and generally the mixing of powders only takes about 5 minutes.
10. Low energy consumption, it is a general mixture
11. Sealed operation, reliable operation, and easy maintenance.