Product Introduction

----------------------------------------------------------------------

Product Introduction:

1) When the battery is at the termination voltage (about 10V) and only the yellow light-emitting diode flashes, the operation should be stopped If continued to use, it will shorten the battery life and should be avoided
2) When replacing output cables or terminals, avoid reversing the polarity of+/- (which may cause malfunctions)
3) If the magnetic yoke is in an overheated state for a long time, it should be fully dissipated before use. When you hear noise or smell an odor, you should stop operating.
4) Be careful of falling or being subjected to strong impacts.
5) Cannot pull cables to move instruments.
6) If the inspected surface is too wide, it should be magnetized in sections and zones, and the effective parts of the sections should overlap to a certain extent.
7) It is strictly prohibited to operate in damp or wet environments.
8) It is strictly prohibited to open or modify the device in case of obstruction. Please contact S M. T. Inquiry. Product features of MP-A2D magnetic particle flaw detector: 1) When the battery output end is connected to the connecting cable, the LED group starts to emit light and flashes at a certain cycle. In the state of charging saturation, the height of the bright pillar can reach 100%
2) Connect the battery and magnetic yoke host with cables
3) As needed, the pole shoes can be rotated and fixed in a right angle direction before use
4) The power on switch should be pressed intermittently, usually for 2 seconds on and 2 seconds off. Apply magnetic powder in the starting state

5) After the operation is completed, immediately remove the power cable to avoid affecting the battery life