Product Introduction:

The MTN-5800 nitrogen blowing concentration device (circular water bath type) is used for sample preparation in liquid phase, gas phase, and mass spectrometry analysis. It adopts * approved technology to concentrate the sample by blowing nitrogen into the surface of the heated sample. This method has the characteristics of time-saving, easy operation, and easy control, and can quickly obtain the expected results. This technology uses solid-phase extraction pretreatment technology instead of traditional liquid extraction and chromatography techniques, enabling rapid separation and purification of samples. Replacing the commonly used rotary evaporator with nitrogen blowing for concentration greatly shortens the analysis time.

The MTN-5800 nitrogen blowing device produced by our company uses water (silicone oil) as the bathroom, which has good and uniform heat transfer, and is conducive to rapid heating and temperature control. Blow nitrogen onto the surface of the sample to achieve anaerobic concentration of the liquid sample. Blow pipes are independent of each other and will not cause cross contamination.

The MTN-5800 nitrogen blowing concentration device (circular water bath type) consists of a constant temperature water bath, temperature controller, gas distribution, sample holder and lifting system, gas flow regulating valve, rotor flowmeter, etc.

Product features:

1. Suitable for test tube conical flasks, centrifuge tubes, etc.

2. Use nitrogen or air as the evaporating agent.

3. PID control constant temperature water and constant temperature sample, heating smoothly.

4. The nitrogen needle fixed disk and stainless steel sample disk can rotate freely 360 degrees.

5. Water level protection to prevent dry burning.

6. Set up a water outlet to facilitate the replacement of water in the container.

7. The sample tray can rotate freely for easy frontal operation.

8. Manually adjust the height of the entire blowing needle to facilitate batch sample processing.

9 . Lift the sample tray as a whole onto the sink for easy removal or insertion of samples.

10. Each blowing needle can independently adjust or turn off the gas flow rate blown out.

11. Use disposable blowing needles to avoid cross contamination.

12. Needle valve gas flowmeter, which controls and displays the total gas consumption.

Specification parameters:

Product model: MTN-5800

Sample size: 12 digits/24 digits

Display mode: Dual 4-digit LED digital display

Sample rack lifting method: manual lifting

Adjustable size (mm): 100

Test tube size (mm): Φ 10-29 (24 digits)

Beaker (test tube) size (mm): Φ 30-55 (12 positions) (optional)

Nitrogen consumption (mL): 330 per needle

Gas flow meter (L): 0-25 (adjustable)

Distance from needle disk to sample disk (mm): 110-210 (manually adjusted)

Sample tray lifting height (mm): 100

Heating method: Constant temperature water bath

Heating power (W): 1000

Temperature control range (℃): Room temperature -150 (silicone oil)/Room temperature -96 (water)

Temperature control accuracy (℃): ±0.2

Drainage: Yes

Inner groove size (mm): Φ 320 × H170

Dimensions (mm): Φ 355 × L402 × H620