Product Details:
The product consists of two series: NGW-L-type single-stage L11-L71 and two-stage L42-L122, suitable for; Taijin lifting and transportation lightweight and general mechanical equipment, applicable conditions are as follows:
The high speed of the high-speed shaft does not exceed 1500r/mln.
The circumferential speed of the gear shall not exceed 15m/s.
The working environment temperature is between -40 ℃ and 45 ℃. If it is below ℃, the lubricating oil should be preheated to above 0 ℃ before starting, and it can run in both directions

4、 Selection method of reducer
When selecting an NGW single-stage planetary reducer, it should be based on the usage conditions:

Px - Select input power

Ps - actual input power

Tx - Select input torque

K1- Usage factor

K2- Coefficient related to lubrication conditions

5、 Selection of Two pole Reducer with Motor
The selection method for bipolar reducers is the same as that for single-stage reducers, but the motor needs to be matched according to its load-bearing capacity.
1. Equipped with motors, Y series vertical asynchronous motors or explosion-proof asynchronous motors.
2. For the convenience of selecting reducers, the matching of electric motors and reducers is compiled and selected in the following three situations:
a. When the shaft power of the reducer is 0.94-1.4 times the motor power, i.e. calculated according to the single-stage selection method, if the product of K1 and K2 is less than 1.4, the motor can be selected for full capacity. Represented by "○" and named as the basic specification. Commonly used for stable continuous or mild; The workload of the hit.
b. The shaft power of the reducer is 1.4-2.5 times the motor power, which means that if the product of K1 and K2 is less than 2.5 after calculation using a single-stage selection method, the motor can be selected for full capacity. Represented by "△", it is commonly used for workloads with moderate or severe impacts.
c. The specific multiple values of items a and b should be determined by comparing the listed power values with the motor power values.
d、 When the power of the motor used is 1.1-1.2 times the input shaft power of the reducer, a single-stage selection method should be used according to the allowable output torque. Safety devices should be installed on the high-speed shaft of the reducer to prevent overload operation.