| Waveform specifications |
|
|
| basic waveform |
Sine wave, square wave, triangular wave, oblique wave noise, arbitrary wave |
|
| Arbitrary waveform generation software |
Windows 95，，98，2000， NT，ME |
|
| AWC function |
Sine wave, square wave, triangular wave, oblique wave, damping, sine index, rising index, falling index, DC noise, freehand drawing |
|
| waveform length |
16 to 16,，383 points |
|
| amplitude resolution |
12 bits |
|
| Sample Rate |
40M Ss |
|
| frequency characteristic |
|
|
| Sine wave square wave |
0.01 Hz to 31MHz |
|
| Triangular wave oblique wave |
0.01 Hz to 2MHz |
|
| noise |
10MHz (64BIT M series) |
|
| output characteristic |
|
|
| output |
Protek9301 (1 channel), Protek9302 (2 channels) |
|
| source impedance |
50 ohm floating |
|
| output device |
Vpp，，Vrms，，dBm，% |
|
| SYNC output |
TTL output for each channel on the front panel |
|
| Channel intermodulation |
<0.05% (only for Protek9302) |
|
| DC deviation |
|
|
| range |
± 5V (limit/peak AC voltage/+/DC voltage value/<5V) |
|
| accuracy |
± 2% of stable value+1mv (DC) |
|
|
|
± 80mv for AC and DC stability values |
|
| Amplitude range |
0.05Vp-p to 10Vp-p into 50ohm |
|
| Sine wave amplitude accuracy (OV DC deviation) |
|
|
|
|
5 - 10Vpp |
0.05 - 5Vpp |
| 0.01 Hz < 100kHz |
±0.2dB |
±0.4dB |
| 100kHz < 20MHz |
±0.3dB |
±0.4dB |
| 20MHz < 25MHz |
±0.6dB |
±0.8dB |
| 25MHz < 31MHz |
±0.9dB |
±0.9dB |
| Square wave amplitude accuracy |
|
|
|
|
5 - 10Vpp |
0.05 - 5Vpp |
| 0.01 Hz < 100kHz |
±3% |
±5% |
| 100kHz < 20MHz |
±6% |
±8% |
| 20MHz < 31MHz |
±15% |
±16% |
| Accuracy of arbitrary wave amplitude for triangular oblique waves |
|
|
|
|
5 - 10Vpp |
0.05 - 5Vpp |
| 0.01 Hz < 100kHz |
±4% |
±8% |
| 100kHz < 2MHz |
±5% |
±9% |
| Sine wave spectrum purity specification |
|
|
| parasitic component |
DC to 2MHz:<- 65dBc (non harmonic) |
|
| 2MHz to 31MHz:<- 65dBc+6dBc/octave (non harmonic) |
|
| subharmonic |
<-50dBc (sine, 5Vpp) |
|
| harmonic distortion |
Harmonic related signals are less than |
|
| DC to 1MHz [sine,，1Vpp] ：< - 45dBc |
|
| 1MHz to 31MHz [sine,，1Vpp] ：< - 32dBc |
|
| Signal characteristic specifications |
|
|
| Square |
|
|
| Rise/fall time |
<15ns (10% to 90%) |
|
| asymmetry |
<Periodic 1%+4nS |
|
| overshoot |
< 5% |
|
| arbitrary waveform |
|
|
| Rise/fall time |
35ns |
|
| Linear measure |
0.5% of full scale output |
|
| Modulation characteristic specification |
|
|
| Amplitude modulation |
|
|
| wave source |
Internal (sine wave, square wave, triangular wave, oblique wave or any other wave) or external signal |
|
| depth |
0 to 100% AM or ± 100% DSBSC |
|
| speed |
Internally 0.001Hz to 10KHz, externally maximum 20KHz |
|
| distort |
<-35dB at 1kHz, 80% depth |
|
| DSB carrier |
Typical value at modulation rate of 1KHz -35dB (DSBSC) |
|
| external input |
± 5V 100% modulation, 100Kohm impedance |
|
| frequency modulation |
|
|
| wave source |
Internal (sine wave, square wave, triangular wave, oblique wave, or any other wave) |
|
| speed |
0.001 Hz to 10KHz |
|
| interval |
0.01MHz to 31MHz (2MHz for triangular and oblique waves) |
|
| Phase modulation |
|
|
| wave source |
Internal (sine wave, square wave, triangular wave, oblique wave, or any other wave) |
|
| speed |
0.001 Hz to 10KHz |
|
| interval |
9999.99
|
|
| Burst modulation |
|
|
| wave form |
Sine wave, square wave, triangular wave, oblique wave or any other wave |
|
| frequency |
2MHz sine wave, square wave, triangular wave, oblique wave or any other wave |
|
| count |
1 to 65000 cycles/burst |
|
| Phase shift |
100 kHz |
|
| SWEep |
|
|
| type |
Linear or logarithmic |
|
| time |
0.001Hz to 10kHz |
|
| interval |
0.01 Hz to 31MHz (2MHz for triangular oblique waves) |
|
| indicated output |
Two indicators can be set at any scanning point (TTL output) |
|
| Scan-Out |
0-10V linear ramp signal,，Synchronous |
|
| Standard Time Base |
|
|
| accuracy |
± 3 ppm (20 ∩ to 30 ∩) |
|
| aging |
± 3 ppm/year |
|
| input |
10MHz/N ± 2ppm, N=1 to 8,，1Vp-p minimum input level |
|
| output |
10MHz，> 1 Vp-p sine 50 ohm |
|
| general |
|
|
| operation temperature |
5 ° C to 40 ° C |
|
| Working humidity |
50% to 80% |
|
| weight |
Protek 9301：8.2kg， Protek9302：8.7kg |
|
| size |
363mm [W] x 109mm [H] x386mm [D] |
|
| interface |
RS-232 (2400 to 19,，200bps) and GPIB (optional) |
|
| power supply |
100/120/220/230 VAC[±10%] 50/60Hz |
|
| power consumption |
Protek 9301：46W， Protek 9302：80W |
