Product Overview:
Resistance rotary level gaugeThere is an instrument motor installed inside the junction box, which is connected to the drive shaft with blades at the other end using a clutch device. When there is no contact with the material, the blades and motor rotate coaxially along the transmission shaft. When the blades come into contact with the material shaft, the motor stops rotating and sends an alarm signal.

Product features:
● It has a good shaft sleeve sealing design, which eliminates the phenomenon of fine powder jamming the shaft and makes the measurement more reliable
The sturdy casing is suitable for any outdoor environment
Imported instrument motor with long service life and reliable operation
● Multiple customized products to choose from, making selection no longer difficult
Four torque adjustment modes, suitable for most materials with specific gravity

Resistance rotary level gaugeApplication
Due to its solid and sturdy structure, it is very suitable for measuring powdered and granular materials such as cement, sand and gravel, grain, feed, pharmaceuticals, etc.

Product specifications and parameters:
Power supply: 110V (A)/220V (B)/24Vdc (C)/24Vav (D), 50/60Hz Power consumption: 3W
Contact capacity: SPDT/3A/220 Applicable specific gravity: 0.5kg/cm3
Motor speed: 1 R P. M (revolutions per minute)
Measurement torque: 0.5-1.0kg-cm (four adjustable sections)</div>
Standard connection: 2-1/2 "× 5kg/cm2 flange, 1" PF tooth or 3/4 "PF tooth (suitable for mini models)

matters needing attention:

Confirm that the blade specifications can pass through the flange hole or tooth opening size
Pay attention to the specific gravity of the material, which must be greater than the applicable specific gravity of the product. Min.ρ=0.3g/cm3
The installation location accessories must not have strong vibration sources
When installing on the low level side, a protective baffle should be added about 300mm above the sensor to prevent material impact
All flanges have a standard thickness of 4mm when not requested by the customer