3.1 Failure disengagement device

The module of the protector is equipped with a failure disengagement device. When the protector fails due to overheating or breakdown, the failure disengagement device can automatically disconnect it from the power grid and provide an indication signal. When the protector is normal, the label displays green, and when it fails and disengages, the label displays red.

3.2 Remote signaling contact

Protectors can be made into varieties with remote signaling contacts. The remote signaling contact is a normally open contact. If one or more modules of the protector fail, the contact will close and send out a fault message. Rated value of remote signaling contact:AC36V、1A.

4 Main structure and working principle

In a three-phase four wire system, three phase wires and one neutral wire are all connected to the grounding wire with protectors (see figure)1）. Under normal circumstances, the protector is in a high resistance state. When there is a surge overvoltage in the power grid due to lightning strikes or other reasons, the protector will immediately conduct in nanoseconds, introducing the surge overvoltage into the ground and protecting the electrical equipment on the power grid. When the surge voltage passes through the protector and disappears, the protector will return to a high resistance state, so as not to affect the normal operation of the power grid. The electrical schematic diagram of the surge protector is shown in the figure2.

5 install

5.1 The protector adopts standard35mmTrack installation;

5.2 Protector adopts2.5~35mmThere are two wiring methods for connecting copper wires of square meters;

a) Connect the power switch to the protector, and then connect the protector to the load end. This method is used for load current100AThe following distribution boxes. The cross-sectional area of the wire should be selected according to the load current (see figure)3）.

b) From the power switch connection to the protector, and also from the power switch connection to the load end. This method is suitable for load current100AThe above distribution box. The cross-sectional area of the wire connected to the protector is not affected by the load current, but the length must not be too long and the total length of the grounding wire must not exceed500mm(See figure)4）

5.3 The grounding wire should be used4 mmTwo color wires with an area of over 2 square meters;

5.4 In order to prevent the failure of surge protectors from affecting the normal operation of the power gridLThe wire protector should be connected in series with a fuse;

The appearance and installation dimensions of the protector are shown in the figure

5 Adjustment, use, and maintenance

6.1 The protector does not need to be adjusted after installation as required;

6.2 As long as the protector is installed properly, it can automatically protect the power grid;

6.3 Regularly check whether the module label is red during operation, and observe whether the indicator light of the fuse is on, and replace the faulty component in a timely manner.

7 Ordering Instructions

1) When placing an order, the model and quantity should be indicated.

For example:TBP-C40/420 100tower

2) The following documents and accessories are included with the product packaging box during shipment:

l Product Qualification Certificate 1share

l operation instructions 1share

l packing list 1share

8 Warning

l Incorrect installation may cause damage to load equipment and systems. Please read this manual carefully before installation. Due to improper installation or failure to confirm installation conditions during the installation process, resulting in product damage, the manufacturer will not fulfill their warranty commitment.

l Improper installation or application may cause harm to individuals and electrical systems. Please read the installation manual carefully before performing the installation. In addition, protective devices must be equipped as required in hazardous operating environments.

l Please be sure to cut off the power supply of the equipment and related circuits before installing this product.

The installation of this product must be completed by a professional electrician holding a work permit