• Adjustable alarm or over temperature protection (OTP) settings can be used to prevent furnace or loading chamber overheating
• Thermocouple disconnect protection cuts off the power supply to the heating element to prevent thermocouple failure and loss of control
• Open the door upwards to keep the heat away from the operator
• There are four independent heating elements in the refractory cement inside the furnace chamber, which make the temperature distribution more uniform
• Door * * switch, when opening the door, the heating element is powered off to protect the operator
• Rear mounted 0.38 in. (0.95cm) port diameter, using independent measuring equipment to monitor the temperature inside the chamber
• LED display screen simultaneously displays two set values and actual furnace temperature in ° C or ° F (programmable model)

Single Setpoint Controller (B1):

• Slide to set and hold values
• A single display screen shows the actual temperature and set point

8-step programmable controller (C1):

• Slide to set heating speed and holding cycle, maintain temperature at the set level for 0.1 to 999.9 minutes
• The 'hold' function can 'hold' the program until the furnace temperature is heated or cooled to the pre-set parameters, and the program will never run beyond the performance of the furnace

including:

Platinel ™ II thermocouple and ceramic furnace plate to protect the bottom heating element.

Note:

The 120V model requires fixed wiring and does not come with a power cord.