Performance characteristics:
1Smooth transmission, low vibration, impact, and noise, large reduction ratio, wide versatility, and can be used in conjunction with various mechanical equipment.

2It can achieve a large transmission ratio through single-stage transmission, with a compact structure. Most models of reducers have good self-locking properties, which can save braking devices for mechanical equipment with braking requirements.

3The meshing friction loss between the worm gear teeth and the worm gear tooth surface is relatively large, so the transmission efficiency is lower than that of gears, and it is prone to heat generation and higher temperature.

4The requirements for lubrication and cooling are higher.

5Good compatibility, the worm gear and worm are manufactured according to national standards, and standard components are used for bearings, oil seals, etc.

6There are two types of box body types: basic type (the box body is a vertical or horizontal structure with a bottom board) and universal type (the box body is a rectangular prism with fixed screw holes on multiple surfaces, without a bottom board or with additional bottom boards, etc.)

7There are two types of input shaft connection methods: basic type (single input shaft and double input shaft) and motor flange.

8The direction of the output and input shaft positions includes the input shaft below and above; Output axis up and down; Input axial up and down.

9, Available2Taiwan or3A multi-stage gearbox is composed of a table reducer to achieve a maximum transmission ratio.

Working conditions:
1The speed of the worm gear cannot exceed1500r/min.

2The working environment temperature is-40℃-+40℃When the working environment temperature is below0℃Before starting, the lubricating oil must be heated to0℃Above, when the working environment temperature is higher than40℃Cooling measures must be taken at this time.
3The worm gear reducer can rotate forward and backward when entering the shaft.

matters needing attention:

1Worm gear shaft must not be used as an input shaft.

2The matching motor (i.e. power) cannot exceed the value specified on the label.

3If the user wants to change the direction of the shaft, they can remove the two end covers of the shaft, take out the worm shaft, and adjust it180Simply install, do not forcefully tap during installation, slowly drive the two shafts to engage.

4Installation method:①Base installation,②Flange installation,③Universal foot installation.

5Output method:①Solid shaft output,②Hollow shaft output.

6Reduction ratio:①Basic type (single level)1：10--1：60；②Combination type (dual level)1：3600；③Combination speed ratios of three or more levels are higher.

7Motor power (input):0.12KW--15KW.