1、 Overview (Stainless Steel Water Meter)
LXS、LXLG、LXSLThe rotary wing and spiral wing stainless steel water meters are measuring instruments used to measure the total volume of water flowing through the tap water pipeline, suitable for industrial and household use.
LXS、LXSLThe type is a wet structure with pointer type（CType and number pointer type（EThere are two types.LXLGThe type is a magnetic transmission dry structure, with digital display, convenient reading, high accuracy, and is not affected by water quality. The dial is always clean and clear.

Stainless steel water meters can be produced with remote transmission modules or intelligent control to produce stainless steel remote transmission water meters and stainless steel prepaid intelligent water meters.

2、 Main features
1Strong anti impurity ability, low pressure loss, and long service life.
2The structure is simple, easy to install and maintain, saving time and effort.
3Low transmission resistance, sensitive and reliable operation, high calculation accuracy.

3、 Technical parameters
1. Flow range

2Maximum allowable error:
aFrom the low zone including the minimum flow to excluding the boundary flow: ±5%
bFrom the high zone including boundary flow to the high zone including overload flow: ±2%
3Water temperature: Cold water gauge0－45℃ (hot water meter ≤95℃）
4Nominal pressure:DN15-DN40≤1.0Mpa DN50-DN150≤1.6 Mpa
5Pressure loss: ≤0.1Mpa

4： Installation size and weight

5、 Notice before use:
1. Water meter inlet3Inside the meter and at the water outlet2No valves, shrink tubing, etc. can be installed within the meter.
2At the bend of the pipeline2Water meters cannot be installed within the meter, as it can easily generate eddy currents.
3During installation, try to stay away from heat sources and pressure tanks as much as possible, at least3Beyond meters.
4If the liquid contains impurities, filter screens must be installed at both ends of the water meter.
5The water meter must be installed horizontally and away from the magnetic field. The dial should be kept horizontal with a maximum inclination of no more than5Degree.
6When water is flowing, the valve should be slowly opened. When water is stopped, the valve should be closed first and then the machine should be stopped to prevent excessive water hammer from damaging the movement.
7There are many impurities inside the newly installed pipeline. Before installing the water meter, the interior of the pipeline should be flushed clean to prevent the movement from being blocked.
8The diameter selection of the water meter should be based on the commonly used flow rate, and the diameter of the piping should be consistent with the nominal diameter of the water meter.